INFO

New Firmware for SwyxPhones L6xx available (V2 R0.90.0) (kb4407)

The information in this article applies to:

  • SwyxWare 2011 R2
  • SwyxWare 2011
  • SwyxPhone L615
  • SwyxWare v7.00
  • SwyxPhone L680
  • SwyxPhone L660
  • SwyxPhone L640
  • SwyxPhone L620

[ Summary | Information ]


Summary

Swyx has released a new firmware V2 R0.90.0 for the SwyxPhones L6xx .

Please note that...

  •  this firmware can only be used with the following SwyxWare versions:
    • SwyxWare 7.0 with Quickfix 6
    • SwyxWare 2011 or higher 

Information

This firmware version fixes the problem, that a L640 gets into a state, where it does not display anything but a bell symbol on incoming calls.

To update the firmware at your SwyxServer you have to perform the following steps related to the installed SwyxWare version:

Open the Server Settings within the SwyxWare Administration and select the tab "SwyxPhone Firmware Update". Within this configuration select the option "Get". Hereby the SwyxServer will contact the Swyx FTP server (ftp.swyx.com) which is configured by default and downloads the latest firmware version.

After this you could validate that the new firmware was download by checking the firmware version information:

If the firmware version (V2 R0.90.0) is listed for all SwyxPhones L6xx, the phones of this type will prompt for a firmware upgrade the next time the user logs on.


Comment

Comment on this article



If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


Note

This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.