INFO

SIP Provider TIPICALL(UK) (kb4646)

The information in this article applies to:

  • SwyxWare 2015
  • SwyxWare 2013

[ Summary | Information | Links ]


Summary

Information und configuration hints for SIP provider TIPICALL (Great Britain/UK).


Information

General information

TIPICALL is offering a registerless SIP trunk. This means that the authentication is based on the public IP address of the SwyxWare server. Therefore, you need a static, public IP address from your ISP assigned to the SwyxWare server.

Configuration

During creation of the SIP Trunkgroup, the profile 'Tipicall (UK)' must be selected. The preconfigured IP address for the Proxy server needs to be checked and adopted if necessary.

In the case where the SwyxWare server is running with a private IP address and the static, public IP address is provided by NAT gateway, it is necessary to configure a STUN server in the properties of the SIP trunk group, under the tab 'SIP'. A list of public STUN servers can e.g. be found at  http://www.voip-info.org/wiki/view/STUN

The actual tests were performed by TIPICALL itself, not by the Swyx TPP.

For your convenience the generated CustomProviderProfiles.config is available for download at the end of this article. Extended information about how to use this file can be found at Configuration and Adaptation of SIP Providers via Provider Profiles (kb3436).

Important: From SwyxWare2013R6 on, the provider profile for IP Directions is already available in the list of provider profiles and the CustomProviderProfiles.config is no longer necessary.

Restrictions
T.38
FAX negotiation and transmission through T.38 is not supported.

Tested Features

  • Incoming/outgoing national calls
  • Incoming/outgoing international calls
  • Correct Calling Line Identification (CLI) on national and international calls
  • CLIP No Screening
  • Holding and retrieving calls
  • Toggeling between two calls
  • Call transfer
  • Conferencing
  • Mutually supported codecs:
    • G.711a
    • G.711µ
    • G.729
  • Incoming/outgoing DTMF signaling in accordance with RFC2833

Test date: 
29/10/2014 with SwyxWare2013R5
17/11/2014 with SwyxWare2015

Overview of tested SIP provider


Links

As far as software supplied or used by us, includes open source elements the additional terms under https://www.swyx.com/open-source apply in addition. An overview which products from the Swyx portfolio include open source elements and which open source license is relevant can be found under https://www.swyx.com/open-source.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.


Comment

Comment on this article



If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


Note

This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.